Hi Jeff As you know I favor Rubber Glides. I've been thinking for a while
it would be nice while chopping to not have to lift the motor in and out
constantly. While percolating on this I figured it'd be nice to have some
easily accessible flat and square(to a thous or so) surfaces to measure off of.
I used the solid mount frame pictured as a welding jig (after a bunch of
measuring to ascertain it's trueness) turned to parallel on my lathe the end
pieces out of angle iron. The tubing is of course DOM. The last picts are the
engine simulator tool in a Dyna. An multi-planar
adjustable arm to the upper spherical rod link connector
is in the planning phase. Tom Rose Mountain Legacy Inc. P.O. Box 828 Dubois, WY 82513 307-455-3265
2 comments:
that is smart!
As I was reading this I'm thinking, this is full of TKRisms. Sure nuff. How's Tom these days?
Post a Comment